What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Page 32-09 step 1 problem

jamescone

Well Known Member
The plans on page 32-09, step 1 say to cut the edge protector 3 3/16” long. I did and then found that they are about 3/8” too short to go all the way around the hole for the flapperon torque. I asked Van's for another piece of the edge protector.
 
Agree

I sent a note 2 weeks ago to Van's. I think I had to cut them to 3 5/8". I did not get an answer back. The aileron control tube fits rather loose in the hole.

The finish kit has a plastic tapered end that has to go on the aileron and into the end of that tube. The looseness may be necessary, not sure.

John Bender
 
Back
Top