ShortSnorter
Well Known Member
I have two questions, both related to the aileron rigging:
1. What is the minimum clearance required between the aileron and the hinge brackets as seen below (The other side has 1/8")?
2. Stupid question, but just want to confirm: Is the entire hardware assembly (bolt, washer(s), bushing, nut) supposed to rotate as one with the aileron? In other words, with everything tightened down, the two washers are sandwiching the bearing which is moving about the race.
Thanks!
1. What is the minimum clearance required between the aileron and the hinge brackets as seen below (The other side has 1/8")?
2. Stupid question, but just want to confirm: Is the entire hardware assembly (bolt, washer(s), bushing, nut) supposed to rotate as one with the aileron? In other words, with everything tightened down, the two washers are sandwiching the bearing which is moving about the race.
Thanks!