Brake Stop

Hi all, We build the RV longeron dies, and in the building of my RV7a and subsequent, I use a cheap combination shear/brake. Its quite useful for small parts, but using the brake was always a pain due to the lack of a back stop and also squaring the material to bend. For each bending job, I would clamp on a bunch of add on pieces to form a stop system. I developed a combo stop/square/down stop. I suspect that many of you also have one of the combo shear/brakes and may find this useful.
I have produced a limited number of these, and if you all like this, I will put it in full production.


See the product page here