Hello Folks,
we're in need of four ne engine vibration isolation mounts for our O-235-H2C powered RV-3B. Unfortunately we don't have the old ones, and VANS can't offer us the mounts for the O-235, they only told us that they are smaller than the O-320 and O-360 mounts.
Which mounts do we need to buy? We measured the flange on the engine mounts side: Inner Diameter (The "bore") is 2" ; the inner diamter of the outer cast is 3 1/4" ; the whole flange is about 5/8" thick.
Hope someone can help us. Thank you!
Simon
we're in need of four ne engine vibration isolation mounts for our O-235-H2C powered RV-3B. Unfortunately we don't have the old ones, and VANS can't offer us the mounts for the O-235, they only told us that they are smaller than the O-320 and O-360 mounts.
Which mounts do we need to buy? We measured the flange on the engine mounts side: Inner Diameter (The "bore") is 2" ; the inner diamter of the outer cast is 3 1/4" ; the whole flange is about 5/8" thick.
Hope someone can help us. Thank you!
Simon