Cowl Camloc interference with rv10 engine mount - help!
Well, I should have read the forums for pitfalls. I've installed my flanges for my milspec camloc cowl installation, and I've just found that four of the flanges are placed so that the camloc receptacles will JUST interfere with the engine mount! (One of the four has a bit more overlap.)
I might be able to shift the location of the camloc on the flange for at least two of these, but I thought I'd ask, in case that's not possible -
Does anyone know of a lower profile camloc receptacle that I could use that wouldn't interfere with the engine mount?
Of course I can always just go with countersunk screws at these four locations, but I'd love to have a consistent look and camloc mechanism if possible.
Thanks all in advance!