Brandon - if it is just one leg of the extrusion, probably no big deal. However, on an RV3B, I had an angle that was also had a bulge that carried into the other leg, if that makes sense.
Vans gladly shipped me a replacement.
If it is just one leg, and the bend doesnt carry into the fat part or other leg, I have used Vern's large Crescent wrench method successfully.
Smart People do Stupid things all the time. I know, I've seen me do'em.
RV6 - Builder/Flying
Fiat G.46 -(restoration in progress, if I have enough life left in me)
RV1 - Proud Pilot.