Hi,
Been lurking and finally getting started on a RV6 project. I purchased this project approximately 18 months ago from the original builder. The quality of workmanship is top notch and now I am trying to not foul it up.
I have elected to go with a fiberglass skirt sikaflexed to the canopy. My skirt is roughly 3/16 thick and I was wondering is most people taper the edges of the skirt. Especially the leading edges.
In this picture you can see where I tapered a small area.
Thank you,
Been lurking and finally getting started on a RV6 project. I purchased this project approximately 18 months ago from the original builder. The quality of workmanship is top notch and now I am trying to not foul it up.
I have elected to go with a fiberglass skirt sikaflexed to the canopy. My skirt is roughly 3/16 thick and I was wondering is most people taper the edges of the skirt. Especially the leading edges.
In this picture you can see where I tapered a small area.
Thank you,