Edge Roll after dimpling?
So I got over enthusiastic and dimpled some of my wing skins before I used my Cleveland edge forming tool to break the edges that overlap.
Am I out of luck, or is there a way to break the edge after dimpling?
(I searched but didn't find an answer)
sagriver at icloud dot com
RV-7 Slider #74572
Empennage completed 11/2016 (sans fiberglass)
Ailerons and flaps completed 3/2017.
Wings completed 12/2017 (sans fiberglass)
Started on QB fuselage 01/2018
Donated and so should you