6" 3M Wheel on a Bench Grinder / Buffer
I used my 6" 3M debur wheel, mounted on my bench grinder to debur all my skins (even the large ones). It makes short work of it and will take off all the notches left from fabrication at the Vans plant. I would do one side of the edge of the skin, moving the skin left to right in front of the debur wheel, then flip it over and do the other side, left to right. Then, if possible with the part, I would do a final debur, running the skin edge straight down the middle of the wheel, in a small groove. I found that when doing the "side to side" deburring, I usually could get the groove to go away, thus not creating any deep set grooves in my wheel. This was my process for almost all parts. On some of the really large skins, I would chuck up a 1" diameter sanding wheel, then debur wheel into my drill, running it along the edges of the skin, inside lightening holes too, on occasion. My $0.02.