HeliCooper
Well Known Member
I read through section 5 a couple times but I still don't understand the trailing edge construction with regard to the RTV. I am assuming you put a thin layer under the entire trailing edge and then on top of it as you work the left skin down. Do I need to make a shim for the clecos to hold the trailing edge down since it is at an angle?
Where exactly do they want you to put the gum wad size globs for the stiffeners? Additionally I read elsewhere in the forum that the permatex ultra grey was the preferred RTV. Is this still correct?
Thanks as always,
Where exactly do they want you to put the gum wad size globs for the stiffeners? Additionally I read elsewhere in the forum that the permatex ultra grey was the preferred RTV. Is this still correct?
Thanks as always,