Hi Guys,
DWG EF4-4 of the RV4 electric flap instructions shows Bearing F3414M which I imagine would have the 1/4 4130 threaded rod, also shown on that page, screwed into it. Googling "F3414M bearing" show images of this bearing that allows a threaded rod to be screwed into it.
The two bearings I received in the Vans flap kit are bearings which have a threaded bolt integral with the bearing. Rather than using a threaded rod that would go into the bearing, am I required to find a internally threaded tube?
Yup, I contacted Vans with a picture of the two bearings on top of DWG EF4-4 to show the contrast and they just sent me two more of the same bearings with the male threaded bolt.
DWG EF4-4 of the RV4 electric flap instructions shows Bearing F3414M which I imagine would have the 1/4 4130 threaded rod, also shown on that page, screwed into it. Googling "F3414M bearing" show images of this bearing that allows a threaded rod to be screwed into it.
The two bearings I received in the Vans flap kit are bearings which have a threaded bolt integral with the bearing. Rather than using a threaded rod that would go into the bearing, am I required to find a internally threaded tube?
Yup, I contacted Vans with a picture of the two bearings on top of DWG EF4-4 to show the contrast and they just sent me two more of the same bearings with the male threaded bolt.