While I'm changing out my cracked cylinder I'm going to check the other 3 to see if there are any sticking valves.
The question is, why not use air to hold the valves in place when removing the retainers?
Most everything I've read on the procedure talks about stuffing 3/8 rope into the cylinder.
Am I missing anything in attempting this with Air?
Thanks
Tim
The question is, why not use air to hold the valves in place when removing the retainers?
Most everything I've read on the procedure talks about stuffing 3/8 rope into the cylinder.
Am I missing anything in attempting this with Air?
Thanks
Tim