kbalch
Well Known Member
Hey Guys,
I managed to screw up the fabrication of my canopy release pushrods by eyeballing the drilled holes in the absence of a drill press just enough to prevent the mechanism from working properly.
Rather than buying a drill press (having come this far on the project without one) and a proper machinist's vise, I wonder if anyone with the correct setup (drill press or mill) would be willing to dash off the two pushrods for me, as described in Section 35-16, Figure 2.
It's probably late in the game for frugality, but I'd prefer not to buy a single-use (or nearly so) tool if I can avoid it...
I'd supply the stock, of course, any reasonable payment, and be glad to buy a beer at SnF or OSH.
I managed to screw up the fabrication of my canopy release pushrods by eyeballing the drilled holes in the absence of a drill press just enough to prevent the mechanism from working properly.
Rather than buying a drill press (having come this far on the project without one) and a proper machinist's vise, I wonder if anyone with the correct setup (drill press or mill) would be willing to dash off the two pushrods for me, as described in Section 35-16, Figure 2.
It's probably late in the game for frugality, but I'd prefer not to buy a single-use (or nearly so) tool if I can avoid it...
I'd supply the stock, of course, any reasonable payment, and be glad to buy a beer at SnF or OSH.