I started on my van?s RV-10 Empennage kit and in the first step of the Vertical Stabilizer, it calls for trimming the rear spar caps (Section 6, Page 2 - Step 1). I made the markings, drew a straight line and trimmed it. When I came back and read the plans again I realized I didn?t straighten the bow while I drew the straight line.
https://imgur.com/a/lLnKD (First time posting a pic)
Attached is the picture of the rear spar cap clamped straight. I placed a piece of scrap aluminum with a straight edge against it to show the issue. Now the question is, is it acceptable to go forward?
https://imgur.com/a/lLnKD (First time posting a pic)
Attached is the picture of the rear spar cap clamped straight. I placed a piece of scrap aluminum with a straight edge against it to show the issue. Now the question is, is it acceptable to go forward?