I did pop for the EA-F4120 VR. Not the kit. Adding my own cooling under the instrument panel.
Not sure if it will have a schematic. Vans sales says the plans are not available and not shown in the kit????
Any on willing to share?
In going through the 18-04-06 and I count 8 wires called out. There are only 6 terminals on the VR. Here are the 8.
1 - Generator yellow
2 - Generator yellow
3 - P204 white (old P156)
4 - P205 white (old P156)
5 - P3069 yellow (pig tail from old P761, connected to P-205)
6 - P3067 2 ends where?
7 - P3068 (one end with battery ground ring terminal) Other end where?
8 - P3070 (Regulator Warning Wire) 2 ends where?
PPL/ASEL 1970 - Sport Pilot since 2004
80 hrs Flying Aeronca Chief 11AC
1130 hrs Flying 46 Piper J-3 Cub
RV-12 E-LSA #120058 AWC Jul 2012 - Bought Flying Oct 2015 with 48TT - Hobbs now 391
LSRM-A Certificate 2016
Special Thanks to EJ Trucks
i have questions about the new VR installation. I have ordered it but I saw the "kit" today of another builder. i can't tell where the VR is supposed to be installed. I guess on the vertical fire wall but where. I think there was supposed to be a template for placement of the NACA duct, and a wiring diagram but there wasn't. How is this installation going to do in rain? Does any body have pictures of the install?
David Heal - Windsor, CA (near Santa Rosa)
EAA #23982 - EAA Technical Counselor and Flight Advisor; CFI - A&I
RV-12 E-LSA #120496 (SV w/ AP and ADS-B) - N124DH flying since March 2014 - 670+ hours (as of Sept 2018)!
VAF donation through June 2019.