Congrats on completing your tail cone! I was checking out your website and see your parts look fantastic, particularly the hinge brackets on your vertical stabilizer. I can't seem to find any civilized way to set the inner rivet on my rudder hinge brackets. I've tried my pneumatic squeezer but the rivet is so close to the bracket that the yoke rubs on it and causes the squeezer to twist sideways. So then I got out a bucking bar which "kind of" worked but I had to hold it so close to the bracket that it beat the living heck out it. I had to drill the rivet out twice now, and for the life of me I can't figure out how other guys seem to do these hinge brackets so cleanly. May I ask how you were able to get yours looking so nice?
Starting on empennage section - August 2016