8 wheel alignment
I've read as many posts as I can find so I'm asking for some help.
I'm flying an 8 that is rock solid to wheel land but as I transition to three point or land three point it gets a little squirely. Nothing unmanageable bit since I've got the wheel pants off I thought I'd measure the alignment.
The measurements were taken with half fuel, pilot in the front, the tail on the ground and grease plates under both main wheels.
I've ordered a few 1/2 degree shims from van's. What do you guys with experience think I should do with regards to shimming.
Port Perry, ON, Canada
7 Tip Up, Titan XIO-360, Sensenich FP Prop, Cummins Spinner, Dynon Skyview, GTR-200.
Registered, insured and certified Airworthy. Almost there...