Originally Posted by AviatorJ
Looks like an air induction inlet... but it's not from my Ram Air kit...
Are you sure it is not part of the ram air kit??
Is the exterior knurled on the end opposite the set screws?
If so, I seem to remember the set screws hold the part to the servo, and the filter can mounts over the knurled area with a hose clamp.
Flying as of 12/4/2010
Phase 1 done, 2/4/2011
Sold after 240+ wonderful hours of flight.
"Flying the airplane is more important than radioing your plight to a person on the ground incapable of understanding or doing anything about it."