EMP@9-11:Reinforcement doubler brace-#27 dimple

On page 9-11, step#4, you're instructed to dimple the #27 holes in the Trim Access Rein. Doubler (E-01410) (thank you helicooper for asking about the #27 dimple dies so that I didn't have to) but you're NOT instructed to dimple the corresponding #27 holes in the Rein. Doubler Brace (E-01411). This is an error in the plans right? I couldn't find anything in the updates or the plan gotchas. Thought I'd ask before swinging away with the hammer.

All three of the holes for the nut plates get dimpled. Check out my build site as there are a few close ups of the exact parts you're talking about prior to them being assembled.