pekuba1610
Member
The short W-306 D Aluminum-Bar is sandwiched between the W-306 B and W-306 C.
In real life the bar is 3/32 smaller than in the drawing.
Using the spacing from the plan, the rivets are extremely near to the edge of the W-306 D bar. Does this matter anything, in this case the piece is sandwiched between the two others, which keep the minimum edge distance?
Or should I move the two AN470-4 away from the bars edges, keeping the m.e.dist. from the bars edge? Doing so the edge distance to the 306 B & C increases.
Peter
In real life the bar is 3/32 smaller than in the drawing.
Using the spacing from the plan, the rivets are extremely near to the edge of the W-306 D bar. Does this matter anything, in this case the piece is sandwiched between the two others, which keep the minimum edge distance?
Or should I move the two AN470-4 away from the bars edges, keeping the m.e.dist. from the bars edge? Doing so the edge distance to the 306 B & C increases.
Peter
Last edited: