Dynon HDX and B&C wiring question

I'm sure I could figure this out eventually (prob already have?) but I'll just ask the experts here. The Dynon EFIS has a low voltage warning built in so I don't really need a lamp. My question is, can I simply eliminate the lamp and wire that is going to screw #5 on the B&C regulator and just leave that screw empty? Also, I'm assuming I still need to send power to the OV sense screw #3 since the regulator uses it for over voltage protection? Thanks for your wisdom, just trying complete a wiring diagram so I can spend money!

Capture by Jereme Carne, on Flickr

Yes, that was my understanding for my install. #3 must go to a bus voltage source and #5 can be empty.

Larry

LR-3C technical manual manual

Page 4, 2nd note.

In part it says "Terminal 5 may be left unconnected."

https://bandc.com/wp-content/uploads/2018/05/lr3c_technical_manual_revC.pdf

johnbright said:

Page 4, 2nd note.

In part it says "Terminal 5 may be left unconnected."

https://bandc.com/wp-content/uploads/2018/05/lr3c_technical_manual_revC.pdf

Click to expand...

Thanks John, I had that document open in another tab before I posted this, must have missed that. I can already tell that this is the part of the build that involves SO MUCH reading that it is easy to miss stuff.

Thanks to both of you.