When I built my HS I got to the very last AD4 rivet on the spar and buggered it up. It's the one in the middle for attaching the tab from the most inboard rib. The angle makes it unsqueezable with a squeezer and I horribly mangled it with the gun. I drilled it out and made a mess of that but managed to finally get all the rivet out of the hole. Tried again twice no luck. The hole is now really wanting to be one size rivet bigger.
If I want to set an AD5, what drill bit is used to make the hole? If I want to pull a rivet there, what is the right rivet to get? If I want a cherrymax rivet there, what tool do I need to pull it cheapest?
Another reason I want to upsize is to make sure my hole is round and regular because it is likely not and I don't want a spar problem down the road.
Where are AD5 rivets gotten in small quantities?
All advice appreciated.
If I want to set an AD5, what drill bit is used to make the hole? If I want to pull a rivet there, what is the right rivet to get? If I want a cherrymax rivet there, what tool do I need to pull it cheapest?
Another reason I want to upsize is to make sure my hole is round and regular because it is likely not and I don't want a spar problem down the road.
Where are AD5 rivets gotten in small quantities?
All advice appreciated.