Can I do the fuel tanks again? Fiberglass sanding is tough work! When is says don’t worry if the glass overlaps the forward edge the work needed to sand it away isn’t mentioned.
The front center is looking pretty good.
On the left side I attached a pic. Getting the overlap off on the front sacrificed some of piece A. There is also metal showing on the aft edge. You can’t see it but there is a bit of a swale depression between the two.
I was going to lay in another piece of glass cut to size to cover this metal and lay it over some small strips in the depression.
On the other side that little corner where the window meets the aft structure looks a lot better but a little bit of the tip of the metal at that corner shows. How critical is that? Should I keep glassing it until I get a edge of glass to the top of the metal? Or will the final epoxy and primer cure my worry?
The front center is looking pretty good.
On the left side I attached a pic. Getting the overlap off on the front sacrificed some of piece A. There is also metal showing on the aft edge. You can’t see it but there is a bit of a swale depression between the two.
I was going to lay in another piece of glass cut to size to cover this metal and lay it over some small strips in the depression.
On the other side that little corner where the window meets the aft structure looks a lot better but a little bit of the tip of the metal at that corner shows. How critical is that? Should I keep glassing it until I get a edge of glass to the top of the metal? Or will the final epoxy and primer cure my worry?
Last edited: