I have just completed about two months of trial and error in routing the throttle and mixture cables to my Airflow Performance FM200A injector. The engine is a Titan IOX-370 with the horizontal sump. It also has a Vetterman 4 pipe exhaust. The combination of all of this meant that there was only one decent (in my opinion) way to route the cables and that was to route them above the intake tubes and just below the oil sump. That presented some challenges and I thought I'd post a couple of pics on how I did it with the hope that it might help someone.
Mixture linkage:
Throttle linkage:
Both linkages operate smoothly and do not chafe or touch any other component.
Let me know if you have any questions.
Mixture linkage:
Throttle linkage:
Both linkages operate smoothly and do not chafe or touch any other component.
Let me know if you have any questions.
