I purchased my RV-12 and am doing my 1st C.I. and see that the rudder cables are so slack, unless the pedals are depressed, that the cables rest on at least two of the bulkheads in the fuselage. I've read some of the comments on this forum and most don't have a problem with the cables being slack, especially since some RV fliers tend to keep their feet on the rudder pedals while flying. I don't always keep my feet on the pedals. Therefore, I'm concerned about wear to cables and the bulkheads. I did not see a post where someone indicated their cables rested on the bulkheads. I'm tending to think that I need to at least check the length/hole spacing of the cable links and if not correct, re-tension the cables by revision or replacement of the links to get these cables off of the bulkheads. Comments are welcomed and appreciated.