Mevans
Active Member
I am ready to place the skins on the frame and start drilling. I have read about two methods, one is to mark out the spacing and drill the holes in the frame, them place the skin on the frame and drill from the underside through the "pilot" hole".
The other option I have seen is the place the skins on the frame, strap it down, the drill pilot holes throughout the underside of the frame, though the skin, then move to the outside to final drill the holes.
Is there a consensus, or another option I am missing?, thanks in advance.
The other option I have seen is the place the skins on the frame, strap it down, the drill pilot holes throughout the underside of the frame, though the skin, then move to the outside to final drill the holes.
Is there a consensus, or another option I am missing?, thanks in advance.