I am having a h#** of a time getting my canopy frame to even some what match what the drawings call for. The contour of the front bow compared to the roll bar is WAY off. I took some measurements from the center (of the canopy frame) down the sides and found that there is 1/2" difference in length between the center of the upper center bar and the centers of the two lower side bars (bows). This makes for about a 1/2" difference in the contours between the roll bar and the forward bow of the canopy frame on the right side. I called Vans and the guy told me to shift the canopy frame off center to make up for it. That would look like poo not to mention it wouldn't solve my problem. I'm tempted to order another canopy frame to see if it would be any better. Only problem with that is they cost $250 and shipping would probably be $2500. Has anyone else had this problem? This is the old style canopy frame that is made up of round tubing instead of the square tubing for the side bows. The Vans guy also recommended either shimming or cutting the canopy frame and re-welding. Shimming 1/2" is not an option in my opinion and hacking up the frame and rewelding seems like an extreme measure to go to. Any advice would be appreciated.