I have a question for the masses. I recently installed my constant speed spinner on my RV-6A. The spinner is centered on the cowling and the gap is about .200" all around. I know that this is on the tight side. My problem is that the OD of the cowl is larger than that of the spinner. There is about 3/8" of frontal area exposed on the cowling. If my spinner was 13 3/4" in diameter, it would be looking great.
Is this a common occurrence? I am leery about just building up the inside of the cowling and sanding down the outside. Would be very difficult to get an even transition, especially with the honeycomb filler inside the cowling.
Any ideas?
Is this a common occurrence? I am leery about just building up the inside of the cowling and sanding down the outside. Would be very difficult to get an even transition, especially with the honeycomb filler inside the cowling.
Any ideas?