cdeerinck
Well Known Member
Am I missing something obvious? I searched Google and VAF to no avail. I'm looking for any information people might have on this...
I got my DJM quadrants today. They look awesome!
Looking at the rear quadrant, I need to cut a hole in the existing part F-860B-L-1, and then make a side panel.
Any feedback on any of the following (or anything I have missed) would be appreciated:
1) Technique for cutting the hole in the existing part. This is a QB, so it is already installed. Is the best bet to use a drill and nibbler, Dremel, or something else?
2) Are there any OP plans that cover the rear throttle? Is there a Part# for the side panel. It looks like the QB already has nut plates in place to accept a cover. The DJM quadrant is hole compatible with what Vans sells.
3) Does anyone have a recommendation on what to use for linkage hardware between the two?
I got my DJM quadrants today. They look awesome!
Looking at the rear quadrant, I need to cut a hole in the existing part F-860B-L-1, and then make a side panel.
Any feedback on any of the following (or anything I have missed) would be appreciated:
1) Technique for cutting the hole in the existing part. This is a QB, so it is already installed. Is the best bet to use a drill and nibbler, Dremel, or something else?
2) Are there any OP plans that cover the rear throttle? Is there a Part# for the side panel. It looks like the QB already has nut plates in place to accept a cover. The DJM quadrant is hole compatible with what Vans sells.
3) Does anyone have a recommendation on what to use for linkage hardware between the two?