JackinMichigan
Well Known Member
I drilled the exhaust probe location a little to high on the #3 cylinder, which is the one that's the most steeply angled toward the engine. As the result the end of the probe is hard up against the engine baffling. I want to relocate it about 3/4" lower, but I 'll need to fill in the hole that's already there.
What's the best way to do that? Could I weld it, or plug it with something, or do I have to buy a new pipe and start over?
Thanx,
Dave
What's the best way to do that? Could I weld it, or plug it with something, or do I have to buy a new pipe and start over?
Thanx,
Dave