dbaflyer
Well Known Member
The fit is relatively good until I clamp the frame to the bubble. There is a substantial gap between the forward bow and the bubble after clamping. There is a gap on the right side by the tape before clamping, but thought that could be closed with shims. Here are some pictures before the clamps where added:
Right side - not clamped to the frame
Left side - not clamped to the frame
This is what happens after clamping the bubble to the frame:
Right side - clamped to frame
Left side - clamped to frame
This is looking at the center to get both sides at once
This does not look right to me. If it is normal it would not be easy to transfer a cut line along the front bow.
I'm at a loss at this darn canopy stuff. Nothing seems to fit right. I can accept that but need some wisdom on moving forward with what I have right now.
Thanks.
Right side - not clamped to the frame
Left side - not clamped to the frame
This is what happens after clamping the bubble to the frame:
Right side - clamped to frame
Left side - clamped to frame
This is looking at the center to get both sides at once
This does not look right to me. If it is normal it would not be easy to transfer a cut line along the front bow.
I'm at a loss at this darn canopy stuff. Nothing seems to fit right. I can accept that but need some wisdom on moving forward with what I have right now.
Thanks.