Good day all,
I'm installing the 4000 in my single seat -4 project.
The EIS 4000 unit is supplied with diodes for the Tach Signal/input (so a unit failure doesn't ground the mag).
Question...the diodes come pre-wired with female spade connectors at one end and male connectors at the other. Is there a polarity for these ?
Which end should point to the mag ?
My apologies if this is a dumb question.
Thanks very much.
Mike
I'm installing the 4000 in my single seat -4 project.
The EIS 4000 unit is supplied with diodes for the Tach Signal/input (so a unit failure doesn't ground the mag).
Question...the diodes come pre-wired with female spade connectors at one end and male connectors at the other. Is there a polarity for these ?
Which end should point to the mag ?
My apologies if this is a dumb question.
Thanks very much.
Mike