On page 23-07, rev 0, the last paragraph in step 1 says that the aft torque tube subassembly gets clocked using a block 1-1/64" placed under the bolt in the arm of the subassembly, however when looking at figure 2 the dimension is 1-1/32". Yes, I know this is a difference of about .015", but I have been making an effort to build as precisely as I can so it would be nice to know which is the correct dimension. I called Van's this morning to ask about the conflict and the gentleman I spoke with said he had never been called about this before so he would have to ask the engineering office before getting back with me. Frankly I'm a bit surprised someone hasn't called them about this before since the conflict is not subtle. Can someone who has already completed this step tell me how they resolved the difference?