roadrunner20
Well Known Member
Need some suggestions on resolving my issue.
On keyed ignition startup... prop will begin start on prop rotation, then reverses slightly, starter re-engages with the grind. Stop
This happens on cold primed start about every second or third start
Here's my setup
left mag: replaced with Surefly, advance 25* timing set on dip switch, set on TDC
right mag; Slick impulse set on 25* BTC
Timing set on starter dot marking.
Engine Superior IO-360
Surefly suggested I look at the voltage at starter to insure > 10V
My starter voltage is 12.8/12.9 volts.
FWIW, I've checked & rechecked timing to above.
On keyed ignition startup... prop will begin start on prop rotation, then reverses slightly, starter re-engages with the grind. Stop
This happens on cold primed start about every second or third start
Here's my setup
left mag: replaced with Surefly, advance 25* timing set on dip switch, set on TDC
right mag; Slick impulse set on 25* BTC
Timing set on starter dot marking.
Engine Superior IO-360
Surefly suggested I look at the voltage at starter to insure > 10V
My starter voltage is 12.8/12.9 volts.
FWIW, I've checked & rechecked timing to above.