Before installing the tailcone on my RV12is I felt it best to leak check the entire fuel system prior to loosing easy access to the fuel filters/pumps on located aft of the baggage bulkhead. The Rotax 912is engine has been installed but I have not completed the avionics installation so I don't have power to the fuel pumps.
Do any fellow builders have any recommendations to pressure / leak test this system using compressed air or is it standard operating procedure to complete the build and test during my first engine run?
Any best practices are appreciated!
Thanks
Rich
Do any fellow builders have any recommendations to pressure / leak test this system using compressed air or is it standard operating procedure to complete the build and test during my first engine run?
Any best practices are appreciated!
Thanks
Rich