I tried installing the F-1037A Bellcrank Angles to the F-1035 Battery /Bellcrank Mount. The plans (10-23, figure 3) call for AN3-5A bolts with a single AN960-10 washer.
I ran one down to torque and it's still loose? The shank of the bolt has bottomed out on the nutplate and has left the assembly a few thousandths loose. The bolt sticks out of the nutplate a 1/4" and the washer is free to spin.
Before I go and either stack washers or downsize to a -4A bolt, did I miss something?
I ran one down to torque and it's still loose? The shank of the bolt has bottomed out on the nutplate and has left the assembly a few thousandths loose. The bolt sticks out of the nutplate a 1/4" and the washer is free to spin.
Before I go and either stack washers or downsize to a -4A bolt, did I miss something?