I have assembled the release mechanism as shown on page 35-15 figure 3. I am ready to drill the release tube and crank, but I am concerned about the way they fit together. Specifically, page 35-16 figure 1 shows the WD-619 inner tube flush with the WD-618-1 outer tube. Mine is about 1/8" back inside the outer tube, as if the inner tube is not long enough. If I drill 0.313" back as the plans show, and drill #12 (0.189") per the plans, my edge distance on the inner tube will be:
+ 0.313 center
- 0.095 hole radius
- 0.125 backspacing
----------------------
.093 edge distance
This seems pretty small. Thoughts?
+ 0.313 center
- 0.095 hole radius
- 0.125 backspacing
----------------------
.093 edge distance
This seems pretty small. Thoughts?