kbalch
Well Known Member
I'm currently working on the AP wiring in my right wing prior to riveting the bottom skins next week. My fuselage kit shipped today, so I'm motivated to get the last of the wing kit done.
In any case, looking at plans page 19-05 Figure 2 (in the upper right corner) at the diagram of connector C407P. Pin 8 correlates to wire C411 (wht/blk). So far, so good. The question arises when one looks at the corresponding connector on the roll servo harness and notices that position 8 is empty.
What is C411's purpose and why is it being dead-ended? I tried Van's, but we're outside of their limited tech support hours and I'm hoping to wrap this up before Monday. Any ideas?
Thanks!
In any case, looking at plans page 19-05 Figure 2 (in the upper right corner) at the diagram of connector C407P. Pin 8 correlates to wire C411 (wht/blk). So far, so good. The question arises when one looks at the corresponding connector on the roll servo harness and notices that position 8 is empty.
What is C411's purpose and why is it being dead-ended? I tried Van's, but we're outside of their limited tech support hours and I'm hoping to wrap this up before Monday. Any ideas?
Thanks!