az_gila
Well Known Member
First, I am not IFR rated but do want my RV-10 panel to be IFR capable for others, so excuse the dumb questions.
As I read the GTN manuals, the Aerosport dual 10 inch EFIS panel with a separate radio stack will not meet the Field of View STC requirements.
So the GTN manual requires these annunciators within the field of view.
The external GPS Navigation annunciator unit must contain, at a minimum, the following annunciations:
? INTEG, INTG or LOI
? TERM
? APR
? MSG
? WPT
The HSI display will be on a Dynon Skyview so I think the GPS/VOR source will be displayed if the 625 is upgraded to a 650. I'm also assuming the Skyview does not display these other listed annunciator indicators. Is that correct?
Looking at commercial units, it appears that TERM/APR should be yellow/amber and INTG/MSG/WPT should be green.
Sounds an easy job for 5 LED indicators and a push-to-test button assembly on the panel - as shown in Steve Melton's 3D printing thread.
Does anyone see any problem with simply adding the 5 LED indicators to the pilots view?
As I read the GTN manuals, the Aerosport dual 10 inch EFIS panel with a separate radio stack will not meet the Field of View STC requirements.
So the GTN manual requires these annunciators within the field of view.
The external GPS Navigation annunciator unit must contain, at a minimum, the following annunciations:
? INTEG, INTG or LOI
? TERM
? APR
? MSG
? WPT
The HSI display will be on a Dynon Skyview so I think the GPS/VOR source will be displayed if the 625 is upgraded to a 650. I'm also assuming the Skyview does not display these other listed annunciator indicators. Is that correct?
Looking at commercial units, it appears that TERM/APR should be yellow/amber and INTG/MSG/WPT should be green.
Sounds an easy job for 5 LED indicators and a push-to-test button assembly on the panel - as shown in Steve Melton's 3D printing thread.
Does anyone see any problem with simply adding the 5 LED indicators to the pilots view?