The small gottcha I have is while drilling page 29-04, step 7 , #20 holes, two per side line up with the AN6-46A bolts. I nicked two places per bolt on the two bolts that were in alignment. Should have looked closer. Oh well, my first replacement parts on the build so far.
Question, on page 29-07 , figure #3 calls out 6, CR3213-4-05. Anyone know why we just do not use all AN470AD4-8's like the center group holes? Also the only rivets close to that are listed as CR3213-4-5 on the inventory list (I do believe, I should have checked again before posting , but the list is in the hangar) Typo?
Thanks Ron
Question, on page 29-07 , figure #3 calls out 6, CR3213-4-05. Anyone know why we just do not use all AN470AD4-8's like the center group holes? Also the only rivets close to that are listed as CR3213-4-5 on the inventory list (I do believe, I should have checked again before posting , but the list is in the hangar) Typo?
Thanks Ron