Stockmanreef
Well Known Member
38-22 tells you to make a feeler gauge that is 2" by 6" by 0.040.
I have yet to find any suitable 0.040 gauge sheet metal in any of the kits. The only stuff close is the U-channel used to ensure that the the canopy does not twist. I guess I could cut that apart now that there is no real use for it, but it would be about 1" wide, which might be OK.
Or did I miss the 0.040 gauge metal in the kit?
Any thoughts about using 0.032 gauge instead of 0.040? If not, what kind of local shops sell sheet aluminum?
thanks
I have yet to find any suitable 0.040 gauge sheet metal in any of the kits. The only stuff close is the U-channel used to ensure that the the canopy does not twist. I guess I could cut that apart now that there is no real use for it, but it would be about 1" wide, which might be OK.
Or did I miss the 0.040 gauge metal in the kit?
Any thoughts about using 0.032 gauge instead of 0.040? If not, what kind of local shops sell sheet aluminum?
thanks