Stockmanreef
Well Known Member
I assume that I am not the first to do this, but.....
when drilling the lower J channel I drilled the single holes on either side of the ends of the nut plate sections. Not the end nut plate hole, but the next one out. I figured out I had screwed up when I rotated 180 and started drilling. one set of holes is off by 1/16 or less, while the others don't overlap.
I assume that I should just not use the lower j channel and order another. I have another set for the other wing, so I really won't lose any time waiting.
I can use the extra piece for practice.
Thoughts?
Ken
when drilling the lower J channel I drilled the single holes on either side of the ends of the nut plate sections. Not the end nut plate hole, but the next one out. I figured out I had screwed up when I rotated 180 and started drilling. one set of holes is off by 1/16 or less, while the others don't overlap.
I assume that I should just not use the lower j channel and order another. I have another set for the other wing, so I really won't lose any time waiting.
I can use the extra piece for practice.
Thoughts?
Ken