On the tail kit page 09-05, Step 1 says enlarge two holes in the elevator front spar. The top one is 5/8, the bottom is 3/8. Problem is, I accidentally drilled them from the wrong side and now they are switched. The 3/8 hole is on top, and 5/8 hole is on bottom.
Can anyone tell me if I need to order a new spar?? It looks like the 5/8 hole is for the trim servo wires, and I can't figure out what the 3/8 hole is for. Van's is closed till Monday, so any help would be much appreciated.
Thanks, Jim
Can anyone tell me if I need to order a new spar?? It looks like the 5/8 hole is for the trim servo wires, and I can't figure out what the 3/8 hole is for. Van's is closed till Monday, so any help would be much appreciated.
Thanks, Jim