What measurements should be completed prior to drilling the rear spar on step 3 of page 44-3?
Dihedral? Incidence? Was talking to a few builders at the airport on Saturday when we did the initial install with hardware bolts and they suggested other kits have specific items to measure. Is the ten just a different kit that it is not required? I know the tail install has a measure you need to take but that is also not pre drilled.
I did notice the two holes in the rear spar from the fuselage and the wing did not perfectly line up but well within what will be drilled to the 3/8" size. I attribute this to just the build process.
If you measure, what did you measure and how did you measure? Appreciated.
E
Dihedral? Incidence? Was talking to a few builders at the airport on Saturday when we did the initial install with hardware bolts and they suggested other kits have specific items to measure. Is the ten just a different kit that it is not required? I know the tail install has a measure you need to take but that is also not pre drilled.
I did notice the two holes in the rear spar from the fuselage and the wing did not perfectly line up but well within what will be drilled to the 3/8" size. I attribute this to just the build process.
If you measure, what did you measure and how did you measure? Appreciated.
E