The back story - working on the wing kit and adding the wings skins. I could have sworn that I had read somewhere I needed to dimple the ribs which are used to form the wing walk because the skin and wing walk stiffener are also dimpled.
I searched the electronic plans high and low and could not find any reference to dimpling the ribs. After wasting a lot of time I finally figured out what was going on.
The paper plans supplied with the wings (Oct 2017) have the left wing page at Rev 1 (Dec 2016) which has a note to dimple the ribs, but the right wing is still at Rev 0 with no dimpling suggested.
The electronic plans supplied end of 2016 are all at revision 0, hence I could not find the note about dimpling, I was beginning to doubt my sanity. There are no updated wing plans on the web, supposedly the source of the latest revisions.
So are the latest plans available anywhere ?
Robert
I searched the electronic plans high and low and could not find any reference to dimpling the ribs. After wasting a lot of time I finally figured out what was going on.
The paper plans supplied with the wings (Oct 2017) have the left wing page at Rev 1 (Dec 2016) which has a note to dimple the ribs, but the right wing is still at Rev 0 with no dimpling suggested.
The electronic plans supplied end of 2016 are all at revision 0, hence I could not find the note about dimpling, I was beginning to doubt my sanity. There are no updated wing plans on the web, supposedly the source of the latest revisions.
So are the latest plans available anywhere ?
Robert