flyboy1963
Well Known Member
Okay gang, I've searched for hours, and come up with nothing at all on the subject! (Parker Cleveland 30-59A unit)
my brake caliper bores are lightly ridged; can I clean these up with a hone? or is that pointless, will just clog up the stones with aluminum guck.
The pucks are a little discoloured, I think a polish will clean them up.
..and...
I see Viton O-rings on the ACS site, but they aren't showing which durometer hardness, and/or temp range is unclear....they show two!
Surely a dozen of you have done this job before, any pireps appreciated!
my brake caliper bores are lightly ridged; can I clean these up with a hone? or is that pointless, will just clog up the stones with aluminum guck.
The pucks are a little discoloured, I think a polish will clean them up.
..and...
I see Viton O-rings on the ACS site, but they aren't showing which durometer hardness, and/or temp range is unclear....they show two!
Surely a dozen of you have done this job before, any pireps appreciated!