Hello all
im finishing up my fuselage QB and i realize the gussets that go on both the main spar and exterior against the gear fairing and side skin are not installed (7114 L & R) I have looked evrywhere in the manual and cannot find where it says these go in. do i install them now? is there a reason they are not installed as per manual as of yet?
i am also wondering about passing the Pitot and AOA tubing as well as wiring from wing to fuselage. The small hole that the drawings allows for below the pushrod hole is not big enough. is it acceptable or common practice to use the pushrod hole for this purpose as well? it goes without saying that everything need be secured not to interfere with the pushrod if so
im finishing up my fuselage QB and i realize the gussets that go on both the main spar and exterior against the gear fairing and side skin are not installed (7114 L & R) I have looked evrywhere in the manual and cannot find where it says these go in. do i install them now? is there a reason they are not installed as per manual as of yet?
i am also wondering about passing the Pitot and AOA tubing as well as wiring from wing to fuselage. The small hole that the drawings allows for below the pushrod hole is not big enough. is it acceptable or common practice to use the pushrod hole for this purpose as well? it goes without saying that everything need be secured not to interfere with the pushrod if so