Anyone having this issue? My latch is about 1/4 inch short, do to the rollers. The manual says "latch arm has been made with excessive material so that the exact location of the hook can be varied..." Problem i'm having is the latch is a bit short and the angle is about 1/8" below the point on the roll bar. Moving this forward approx 1/4" will bring the angle up, I suppose this could be bent to the proper angle if needed. And I dislike having to grind the rollers to get the roll bars to match, however before i do anything... I'm looking for any alternatives.
Thanks!
IMG_20171118_224933 by SkyPilot181, on Flickr
IMG_20171118_224922 by SkyPilot181, on Flickr
p.s. The rails are not screwed in yet, hence why the washers are not in place.
Thanks!
IMG_20171118_224933 by SkyPilot181, on Flickr
IMG_20171118_224922 by SkyPilot181, on Flickr
p.s. The rails are not screwed in yet, hence why the washers are not in place.
Last edited: