Hi Guys
So I have just completed dimpling the skins for my RV4 Horizontal Stab, and now it is time to dimple the rib and spar flanges using my squeezer. My question is do I just dimple these flanges normally? My worry is that will a normal dimple accept the dimple on the skin(will it be deep enough), as in will the skin sit flush on the rib flange when riveting?
I have read of Guys running a deburring tool on the flange dimple to make it slightly deeper and also of Guys using fuel tank dimple dies on the flange to give a slightly deeper dimple.
Any advice would be greatly appreciated
Thank you
So I have just completed dimpling the skins for my RV4 Horizontal Stab, and now it is time to dimple the rib and spar flanges using my squeezer. My question is do I just dimple these flanges normally? My worry is that will a normal dimple accept the dimple on the skin(will it be deep enough), as in will the skin sit flush on the rib flange when riveting?
I have read of Guys running a deburring tool on the flange dimple to make it slightly deeper and also of Guys using fuel tank dimple dies on the flange to give a slightly deeper dimple.
Any advice would be greatly appreciated
Thank you