Freightdawg
Well Known Member
I'm already off to a bad start, which is to say no start at all.
Step 1: enlarge the brake line exit hole in the bottom skin to 5/8 as called out in fig 1.
Glad that was already done before the gear mount was in place.
Step 2: Install the fitting...
But the fitting doesn't fit. Surely Vans didn't mean to enlarge the hole in the gear mount to 5/8 also. I'm guessing it needs to be enlarged to 7/16 since it's a -4D fitting(?)
Am I missing something?
Step 1: enlarge the brake line exit hole in the bottom skin to 5/8 as called out in fig 1.
Glad that was already done before the gear mount was in place.
Step 2: Install the fitting...
But the fitting doesn't fit. Surely Vans didn't mean to enlarge the hole in the gear mount to 5/8 also. I'm guessing it needs to be enlarged to 7/16 since it's a -4D fitting(?)
Am I missing something?
Last edited: